Install a third bracket to support the rod by its center for any quilt over four feet in width. When measuring to determine where your brackets will go, mark where the top and bottom of each bracket will be, as well as the screw holes. If possible, work with a partner who can stand back at a distance and verify that your markings are level. To ease the brackets’ installation, drill a shallow pilot hole for each screw’s marking. Remove the screw and place the bracket against the wall with its screw holes lined up over your pilot holes.
Be aware that some wall paint may be resistant to adhesive backings. Alternately, screw or nail a wooden board to the wall and attach the velcro strips to that. Choose a board that is 2 inches wide and a half-inch thick. Cut its length to 2 to 4 inches less than the quilt’s width to hide it from view. Use more strips than you think you might need to ensure they will hold the quilt’s weight. Line the top at frequent intervals and/or double, triple or quadruple the number of strips used at each interval. Strips can be doubly secured to the quilt by hand-sewing or pinning them. This method is probably best suited for smaller, lighter quilts.
Hang the frame by its corners with nails or screws, or according to the directions of any hardware that may be included. Do not cover the quilt with glass. Blocking air circulation may lead to mold and mildew. Use rust-free staples to avoid staining.
Use vacuuming as your primary cleaning method to avoid damaging the quilt through excessive washing. Do not soak your quilt if it contains: ink or dyes that may run; glazed, silk, or woolen fabrics; signs of weak stitching or other damage. Washing machines, dryers, dry-cleaning, and ironing could all ruin your quilt.
