If you can’t drill into your walls, you can also use adhesive-backed hooks to hold the curtain rod. Put them in the same position as you would the brackets and allow them to set on the wall for at least 1 hour. If you have a recessed window, you can also use a tension rod inside of the window well. Twist the tension rod until it’s 1⁄2 in (1. 3 cm) wider than the window. Use a double curtain rod if you want to hang voile behind a different type of curtain. That way, you can close a thicker curtain over the voile to get more privacy.
Get 2 voile panels if you want curtains that open up in the middle. Each panel should be as wide as the full width of the window.
You can buy curtain hooks from any home goods store. If your voile curtain doesn’t have holes or pockets, then it will have an area on top where you can easily slide the curtain rod through it.
If you’re using a tension rod to hang your voile, slide one end of the rod into the window well and shimmy the other side in until it feels tight against the sides.
You can screw decorative hooks, or finials, into your wall or you can use adhesive-backed hooks if you don’t want to cause any wall damage. Make sure to get hooks that match the aesthetic of your room.
You may also set a curtain rod on the hooks and loop the voile around the center of the rod. This can add a small decorative touch to the top of your window.
You don’t have to tie the voile to the hook if you don’t want to.
Use thread that’s the same color as your voile so it’s not visible.
